WSC-Unit 1pc

Packaging size: 1 piece

Application and filter system for the WSC Cleaning System, which offers a very efficient and cost-effective solution to eliminate rust and calcification in water circuits of temperature control units and moulds.

Even the thinnest calcification in mould ducts and heating elements are a thermal isolator that considerably slows down heating and cooling cycles.

The consequence: lower rates of production and higher rates of rejects.

The portable WSC-Unit, which is exclusively made of non-corrosive materials, contains a pressure and heat-resistant filter housing with integrated fine filter and neodymium magnet that binds coarse rust particles and thus extends the filter life.

At the same time, the filter cup holds the cleaning agents for the respective cleaning process.

The pump of the temperature control unit admixes the cleaning concentrates (WSC-Phase 1 and WSC-Phase 2) to the circulating water and activated the decalcification and rust removal process.

The cleaning effect is increased by heating the cycle up to a maximum of 80 °C.

Technical specifications:

Dimensions (without tubes): 460 x 320 x 280 mm (H x W x D)
Weight: 7.2 kg
Filter: 10 inches / pore size: 10 µm / max. filling capacity: 1.2 l
Tube connections: 1/2-inch (20.8-mm) internal thread with sealing cone
Internal tube diameter: 9.5 mm
Tube length: 1x 600 mm / 1x 1.200 mm

The WSC Cleaning System consists of the two cleaning concentrates WSC-Phase 1 and WSC-Phase 2 as well as the WSC-Unit.